Results 1 to 10 of 12
Threaded View
-
03-05-2015, 08:05 PM #7
The tiny fan I do not believe can be turned off. It comes on the moment the printer is powered up and doesn't shut off. The larger one that has the duct that blows on the extruded plastic is controlled by gcode or on the control panel. Is there an established fan use for PLA? On at what layer? On how much, I mean at what %?
For ABS I set it to off until layer 5 then 30%. This has worked well for me. Not sure if its right.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion