Rumba and Auto-Bed level

[SgtToe]

Hi All I have purchased the micro switch and servo that is referenced in the zenmaster videos and will be printing Clough42's cooling shroud and ABL parts soon. I quickly read through all 14 pages of this post and was overwhelmed.

After I install the parts would the proper course of events be as follows?

1. Update my firmware from the default that I got from Makerfarm to the newest version?
2. Follow steps in post number 118 on this thread by ex-egll.

that it?

[Roxy]

Hi All I have purchased the micro switch and servo that is referenced in the zenmaster videos and will be printing Clough42's cooling shroud and ABL parts soon. I quickly read through all 14 pages of this post and was overwhelmed.

After I install the parts would the proper course of events be as follows?

1. Update my firmware from the default that I got from Makerfarm to the newest version?
2. Follow steps in post number 118 on this thread by ex-egll.

that it?

My suggestion would be to get the BeckDac release at: https://github.com/beckdac/Marlin

That will be very close to what you need. Wire things up and if you have questions or problems, there will be a number of people here that can help you.

[ex-egll]

I agree with Roxy, having gone through this recently! With the BeckDac release, very few changes are needed. If you need a list of what I changed let me know.