Subscribe to Our Newsletter Advertise
Close



Results 1 to 2 of 2

Thread: Printing PLA

Hybrid View

  1. 02-04-2015, 09:54 AM #1
    stevendm
    stevendm is offline
    Student
    Join Date
    Jan 2015
    Location
    Texas, USA
    Posts
    17

    Printing PLA

    Hi All,

    I am new to the FlashForge Creator Pro (it will be delivered today) but I have had a Da Vinci for a few months. I am familiar with printing ABS but not PLA.

    According to the manual I should remove the plexiglass enclosure when printing PLA. Is that correct?
    Reply With Quote Reply With Quote
  2. 02-04-2015, 10:07 AM #2
    ssayer
    ssayer is offline
    Engineer-in-Training ssayer's Avatar
    Join Date
    Oct 2014
    Location
    Lakeville, Michigan
    Posts
    369
    I've never taken mine apart. Never saw the need. OTOH, I made the active cooling fan on thingiverse right off (you need to buy a 40mm motor) which I use any time I'm printing a thin part (like the deer with antlers that I posted in another thread)...
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules