DaVinci 1 failed on first demo print. Error 0040, SD card read write failure...

[Geoff]

Before trying my own STL files I thought I'd get it to do a demo. It stopped and gave me a 0040 (cannot read\write SD card) error. XYZprinting said they'll reply to my support request within 3 days. 3 days!
Anyone know about this error?


And anyone know how I should reset the machine... It is flashing and beeping in the middle of a stopped print. How do I switch it off safely?

The site tells me to check the SD card, but no documents tell me how to get to the SD card.

If your machine ever stops printing or jams, pull the plug from the wall ASAP or hit the physical power switch. If the machine has failed and leaves the extruder on and for some reason doesnt run the fan, it will overheat the extruder. You wont hurt the machine even if you turn it off while its printing.

[owenransen]

If your machine ever stops printing or jams, pull the plug from the wall ASAP or hit the physical power switch. If the machine has failed and leaves the extruder on and for some reason doesnt run the fan, it will overheat the extruder. You wont hurt the machine even if you turn it off while its printing.

The machine had stopped with an error message in the panel, the infamous 0040, was flashing its internal light, and "beeping". I assumed that it knew what it was diong, but I'm glad to know I can power down safely in any future emergencies, thanks!

Here's the full story, with pictures: http://owenransen.blogspot.it/