Results 1 to 5 of 5
Thread: Pretty sure I killed my arduino
Hybrid View
-
01-20-2015, 11:26 PM #1
You probably blew the circuit that drops 12VDC to 5VDC which is what the board runs on. Have a look underneath the board to see if there is a blackened trace line. That's what went phutt on my board. Unfortunately, you're in a remove and replace situation. Cough up another forty bucks, bro. If this is where the short circuit happened, then everything donline from there should be OK.
OME
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion