Results 1 to 10 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
Threaded View
-
08-07-2016, 11:55 AM #11
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
Looking good! You might make some careful measurements of the PTFE tubes that are provided with the kit. That way should you later desire to, you could make a jig to cut bulk PTFE tubing to size. Looks like they are doing everything possible to fully support/surround the filament with the PTFE tube for its entire length from the drive gear to the hot end.
Are those brass sleeves for the heater inserts?
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion