Quote Originally Posted by DarkAlchemist View Post
See, this is why when I see all of these printed glass corner holders on Thingiverse I laugh at them because if it can be printed it shouldn't be used on something that is going to get hot. Seriously, we use a heated bed to help it hold it down around the Tg of the plastic yet it is being used around the same heat source? Seriously? It makes no sense and I am surprised the holders work as I know from my own experiences those screws, even SS (only slows down the heat progression not stops it) can get hot enough to burn you a nice blister if it is touching the HPB especially when doing ABS and the HPB is at 110c.
I don't like the plastic glass holders either. The problem I have is I have to re-tighten them after each heat cycle. My solution is to use the Maghold plate and glue the glass to the top of the spring steel. It works well, except for my Maghold plate was warped. Putting a glass plate on top of the Maghold helped but I used 1/8" glass and it could bend just enough to follow the warp of the Maghold plate. I shipped my Maghold plate back yesterday to be replaced. I hope the replacement is more flat.