Results 1 to 10 of 102
Thread: Itty Bitty Double FLEX Extruder
Threaded View
-
07-09-2015, 10:18 AM #26
No, actually im using it with a Dual setup..but i don't see why you couldn't just mount one side only. Then when you are ready, you can setup the other side. Your gears should spin freely with no belt attached, obviously with the belts attached and the printer "OFF" there will be some resistance since now the motor is engaged. And yes it is quite hard to turn manually for extruding than the stock Greg Extruder...you have to turn it much much slower..
If you have the RAMBO board like i do..my Digital Pot is set to 135 for my 3mm setup....on my 1.75 setup it is set to 100 since it requires less pressure to extrude the thinner filament, hence it wont skip.
here is a pic of when i had the single setup
here is my Dual Flex setup
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion