Results 1 to 10 of 64
Threaded View
-
07-24-2014, 10:39 AM #9
- Join Date
- Jul 2014
- Posts
- 305
Thank you for your replies!
My other prints had a little issue with the first layer as can be seen from my previous post. This one was just a lot worse. I am not using a raft just printing straight onto the printing bed. I am using a heated bed at 65*c with PLA. My first layer print temperature is 230*c, I have tried lowering both of these but the print was even worse then what I included above.
Would you raise the printing bed slightly? Or fix the Z-stop within Slic3r?
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help