Results 1 to 10 of 64
Threaded View
-
07-24-2014, 09:58 AM #8
First, lets give credit where its due! Your top with the single cube looks VERY good. It looks better than what mine looks like. Mine usually ends up pretty rounded because of the heat.
Are you printing with a raft? It kind of looks like it. I suspect it might be worth while to try printing the first layer directly on the bed. And it might be interesting to stop the printer 90% of the way through the first layer and take a picture of that for us. PrintBus is probably right about the nozzle being too high to get good adhesion. That picture of the bottom of the print shows the filament pretty 'round'. What that means is it is not getting squished down into the bed and fusing one tube to the next. And that is probably helping cause other problems like the lower left corner in the first print. The filament doesnt have anything to stick to from the previous layer and the corner does not end up square. (Instead, the filament gets pulled and the corner gets rounded)
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help