Quote Originally Posted by Dave Bodnar View Post
It is a bit tricky to get the screws into the stepper motors - pull the fan & heat sink back a bit to get the threaded hole in the motor visible - once you get one in the other is a snap.

dave
Thanks again!
I got it all put back together but may have to take it apart again.
The reason I took it apart in the first place was because I had problems printing. I just got PLA for the first time and so I tried printing with it, but far too often the gear stops gripping the filament. Any recommendations? It gets halfway through a print before it stops grabbing hold, which is a bit frustrating.
Again this is my first time with PLA so I'm really a noob at it hahaha
Thanks again