Quote Originally Posted by Petmagnet13 View Post
Thanks for the advice!
After I posted the message, I continued to look deeper and found that one of them had fallen into the bottom of the printer. When I went to retrieve it, it seemed there was another one the same size being used to hold on the board for the buttons, so I replaced that one with a hand-cut one and took the exact match, that way I knew it would work.
Now I'm just having troubles reassembling it... The screws don't seem to want to go back into the stepper motor...
It is a bit tricky to get the screws into the stepper motors - pull the fan & heat sink back a bit to get the threaded hole in the motor visible - once you get one in the other is a snap.

dave