Itty Bitty Double FLEX Extruder

[voodoo28]

Great job C42!...One thing I would suggest to add to your website instruction page is the use of the PTFE Tubing for the 1.75mm setp. I should have mine all setup by tonight..

[clough42]

Great job C42!...One thing I would suggest to add to your website instruction page is the use of the PTFE Tubing for the 1.75mm setp. I should have mine all setup by tonight..

I have included a block bored out to work with the E3Dv6 1.75mm with the PTFE tube. It's bored out to work with or without the fitting.

Are you looking for a PTFE tube version for the Hexagon?

[clough42]

Here are some photos of my setup. The big difference between the release version and the one sniffle is running are the cable management tie points.



And here's a totally ridiculous test print. It's a 1:10 short course truck tire. The black material is ABS and the red is NinjaFlex. Printed at 30mm/s with .2mm layers, it took 14 hours. I photographed it on the 8x8 printer bed for scale.