Qidi Tech 1 - Replicator 1 clone

[Talon 3D]

When I run the bed at 110 for ABS that does not happen but if I drop it any I get the same thing. Warping.

Here is a cube I am doing, trying to dial in some Hatchbox ABS. The pics are of the same spot on the cube from different angles.
ABS - 210
Bed 90
QIDI Tech-1 fully enclosed
S3D
This is the corner set for start points. I have been turning down the temp to see if this will go away or reduce but it is not.
I am ran a print with start point optimized to see how that did and that spot is better but still there.


[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]