Results 3,251 to 3,260 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
-
09-21-2016, 03:28 PM #3251
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
09-21-2016, 03:35 PM #3252
-
09-21-2016, 04:07 PM #3253
- Join Date
- Feb 2016
- Posts
- 360
-
09-21-2016, 05:01 PM #3254
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
09-21-2016, 05:06 PM #3255
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
09-21-2016, 05:09 PM #3256
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
09-21-2016, 05:21 PM #3257
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
09-21-2016, 05:21 PM #3258
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
09-21-2016, 05:40 PM #3259
-
09-21-2016, 05:46 PM #3260
- Join Date
- Sep 2016
- Posts
- 80
Hi all. I've had my Qidi a week now and am having an interesting time with it.
I'm hoping I can get some help on a couple questions.
First of all, I'm trying to figure out how to get past some first layer issues. Is there a way in the Makerbot software to increase the thickness of only the bottom layers? I haven't found anything useful yet.
Second, is there a practical alternative to the Makerbot Desktop software? I've got some practice with other software for an MP Mini (which I liked a lot better than the Makerbot software), and really don't like the Makerbot software.
Finally (for now) I am having a seriously tough time getting my prints off my bed. Anything wide, such as a 3" Catan hex takes some major effort to get off the bed, and typically involves putting some gouges on the sides of the piece.
Suggestions?
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion