Results 3,251 to 3,260 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
-
09-21-2016, 03:28 PM #3251
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
09-21-2016, 03:35 PM #3252
-
09-21-2016, 04:07 PM #3253
- Join Date
- Feb 2016
- Posts
- 360
-
09-21-2016, 05:01 PM #3254
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
09-21-2016, 05:06 PM #3255
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
09-21-2016, 05:09 PM #3256
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
09-21-2016, 05:21 PM #3257
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
09-21-2016, 05:21 PM #3258
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
09-21-2016, 05:40 PM #3259
-
09-21-2016, 05:46 PM #3260
- Join Date
- Sep 2016
- Posts
- 80
Hi all. I've had my Qidi a week now and am having an interesting time with it.
I'm hoping I can get some help on a couple questions.
First of all, I'm trying to figure out how to get past some first layer issues. Is there a way in the Makerbot software to increase the thickness of only the bottom layers? I haven't found anything useful yet.
Second, is there a practical alternative to the Makerbot Desktop software? I've got some practice with other software for an MP Mini (which I liked a lot better than the Makerbot software), and really don't like the Makerbot software.
Finally (for now) I am having a seriously tough time getting my prints off my bed. Anything wide, such as a 3" Catan hex takes some major effort to get off the bed, and typically involves putting some gouges on the sides of the piece.
Suggestions?
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion