Originally Posted by
protechtrader
It is from top to bottom on the one side.
I think it is mechanical as even though there wasn't any intentional changes I had the belts off as I cleaned out the printer, the bars and extruder. I lightly lubed the X Y Z bars and pillow bearings with a drop of oil each and reassembled. Somehow causing this, but I am not sure how yet. I verified screws seem good, belts seem good, operation seems as smooth as it has been before, so not sure were I caused this issue yet.
Thanks for your reply.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help