Results 1 to 10 of 40
Thread: PLA Suddenly Jamming Mid-Print
Threaded View
-
09-10-2016, 04:55 PM #31
- Join Date
- Feb 2016
- Posts
- 24
I'm going to assume your first point is that I shouldn't need to adjust the current into the stepper motors (which is something I still am suspicious as to whether or not it may be part of my problem).
So, I have tried both reducing the extrusion multipliers and the speed of extrusion, and I only end up with more problems than what I started with. The printer doesn't even start with a good first layer and the whole print is a mess before the third layer.
Also, the Qidi Tech doesn't have the ability to adjust the tension on the extruder drive.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion