Results 2,591 to 2,600 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
-
07-29-2016, 07:43 PM #2591
http://www.thingiverse.com/thing:390209
This is a bolt on one that I've had out there for a while. It repositions the switch.
-
07-29-2016, 07:55 PM #2592
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
07-29-2016, 08:00 PM #2593
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
07-29-2016, 08:02 PM #2594
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
07-29-2016, 08:10 PM #2595
-
07-29-2016, 08:20 PM #2596
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
07-29-2016, 08:22 PM #2597
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
07-29-2016, 08:48 PM #2598
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
Ok, just printed this one http://www.thingiverse.com/thing:1670502
fits great with the 10's it is made for a plate a bit thinner that .25" so be careful!!!
-
07-30-2016, 10:50 AM #2599
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
W, how is the Flexion install going?
-
07-30-2016, 10:57 AM #2600
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
Have not started yet. Wanted to get a few other little issues ironed out first. I think I found that a good first layer height for PLA is 70%. Leaving ABS at 90% for now, seems ok.
The new shim is good. allows to crank down the adjusters more which I thin tightens it up a bit.
Now trying to make new corner brackets to hold the glass in place. Once I finish these things I may start on the install. Looks like storms so this afternoon may be a good time to install and not print in case power goes out!
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help