Results 1 to 10 of 321
Thread: Flashforge 3D Creator forum.
Threaded View
-
03-14-2014, 07:52 AM #11
- Join Date
- Mar 2014
- Posts
- 8
Thanks for the advice!
After I posted the message, I continued to look deeper and found that one of them had fallen into the bottom of the printer. When I went to retrieve it, it seemed there was another one the same size being used to hold on the board for the buttons, so I replaced that one with a hand-cut one and took the exact match, that way I knew it would work.
Now I'm just having troubles reassembling it... The screws don't seem to want to go back into the stepper motor...
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion