Quote Originally Posted by orm255 View Post
The current settings for retractions are:
Distance: 2.00 mm
Extra Distance: 0.00 mm
Vertical Lift: 0.00 mm
Speed: 30.00 mm/s

The starting position was set to optimize for fastest printing.
Should it be set manually?
If yes, then what would be a good location (x,0 / y,0) or center of build plate?
http://imgur.com/XupDqlg
Is there any particular reason you have your nozzle diameter set to 0.38?

The center location to start the print is the best option as you get the best levelling in the center