Results 1 to 10 of 11
Thread: Help with retraction settings
Threaded View
-
06-28-2016, 06:39 AM #5
- Join Date
- Jun 2016
- Posts
- 6
I tried a few more prints and I may have found the culprit.
It may have been retraction vertical lift as after disabling this setting, the print had almost no stringing at all.
I have reduced the temperature to 190°c and this seems to have helped the print.
There are still small pits in the surface of the print and I also suspect that there is some wobble or minor misalignment between the x and y axis (visible on the windows).
http://imgur.com/a/Z8CeJ
Anyone know if I'm right?
If that is the case, does anyone know how this can be fixed/corrected?
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion