Results 1 to 10 of 40
Thread: PLA Suddenly Jamming Mid-Print
Threaded View
-
06-03-2016, 09:31 PM #6
- Join Date
- Feb 2016
- Posts
- 24
Hmm. That'd suck if that's the issue. Are there some good ways to test if that is definitely the problem? I don't have "popping" which I've heard is a common symptom of PLA hydration.
Though, I wouldn't be surprised if the moisture is the cause, because I do live in a fairly humid environment. But I was using the PLA before I started using ABS and it was working quite well for at least over a month without any special containment. Although, that was during the winter and subsequently a drier part of the year.
I just want to isolate if that is absolutely the cause, since that will allow me to more directly address the problem.
By the way, what do you mean by "pulling"? If you're referring to how stretched the filament is, I think that's because of how I pulled out the filament when I was removing the blockage. Most other times I removed the filament, it wasn't like that.Last edited by Ryuluce; 06-03-2016 at 09:39 PM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help