Can anyone help me troubleshoot my prints?

So far, I've been very happy with the quality of the prints I've gotten, especially since this is my first-ever 3D printer. I am getting some issues with stringing and oozing (see picture below). I tried the tips on the S3D troubleshooting page but I still get some issues.



I'm using the PLA provided by QIDI. My process settings:

Extruder temp: 190C
Bed: 60 C
Retraction: increased from 1.0 to 2.0 mm
Retraction speed: increased from 1200 mm/min to 1300 mm/min

Given the 3 main variables I'm aware of (print temp, retraction distance and retraction speed), I'm not sure which should try to fix next. I know the long span between the highest parts contributes but there are strings over shorter distances. I'm not sure I should lower the extruder temp any further (in the print, you can see the right it had some bed adhesion issues, although all others stuck really well).

Suggestions?