Qidi Tech 1 - Replicator 1 clone

[DJalin1]

Those of you considering installing a glass plate, should also consider using a sheet of PEI. On the advice of a friend, I installed it, and it's amazing how well it works. I printed a PETG part last night that took the entire length of the bed and about 3 inches wide, and after about 2 minutes of cooling, it just popped off. Preparation is nothing more than a quick wipe with paper towel and alcohol. I've used it with PLA and PETG with never a stuck part.

http://www.amazon.com/gp/product/B00...ilpage_o09_s00

One sheet is enough to do the bed two times.

Cheers,
Joe

Do you stick it to the Print Bed if not how do you secure it? Is it removable?
I have seen installation of PEI by using double stick tape and securing it to the Print Bed. I would prefer a way to keep it removable.

I have loved using glass but I have actually run into a problem with the loss of 1/4 inch of z-axis. A Dice Tower that I want to scale up.