Results 1 to 10 of 21
Thread: Prints are sticking to well?
Threaded View
-
03-12-2016, 07:08 PM #11
It's ok for PLA, rubbish for ABS sadly, it really doesn't like a high heat bed.
I really just use the aluminum bed, kapton over that and blue tape over the kapton - not sure how PLA can't stick for you on blue tape...
ABS on kapton with a glue stick, or PLA on blue tape, glue stick...
I think I go through about 3-4 Bostick glue sticks a week, they are my life savers.Hex3D - 3D Printing and Design http://www.hex3d.com
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion