Results 1 to 10 of 95
Thread: 12" I3V Build
Threaded View
-
03-11-2016, 12:31 PM #31
- Join Date
- Nov 2015
- Posts
- 73
IMG_20160311_123110319.jpgIMG_20160310_213412908.jpgIMG_20160310_213500621.jpg
Well after 4 tries I finally have a finished part that works. First one is the one that was 2x the size it should have been because I forgot I measured diameter but was entering radius in Sketchup. Second is the first in the 2nd picture, I made it slightly too small and printed it in the wrong orientation so it broke. Middle one I used the profile from the first and managed to screw up the radius of the circle I drew again. Attached a 20.1mm circle to the point that was supposed to be 17.3mm so it was too big. Next one I got right and you can see it fitting on. I might make it wrap around a little more and slightly smaller so it snaps on a bit more positively, but that one won't fall off on it's own so I'll likely leave it alone for now. Now it's time to design the case for my glasses.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion