Results 1 to 4 of 4
Thread: flashforge sd software
-
02-12-2016, 08:50 AM #1
- Join Date
- Feb 2016
- Location
- Midwest
- Posts
- 3
flashforge sd software
I just received a flash forge creator pro today. I have it setup and ready to run a test print. However the SD card that was supposed to come with it, was not in the package. I would at least like to print a test but I cannot do that without the sd card. Does anyone know where I might be able to download this software so I can transfer it to an sd card?
-
02-12-2016, 02:15 PM #2
no actual software needed on the card just x3g files.
here's the link to software that's actually a lot better than the crap on the card: http://3dprintboard.com/showthread.php?12562-makerware-bundle-of-awesome-2-4-27-for-x86-computers
go to thingiverse.com to download stl files. then run the stl file through the makerware slicer and the x3g file it generates is what you print :-)
-
02-12-2016, 02:59 PM #3
- Join Date
- Feb 2016
- Location
- Midwest
- Posts
- 3
Thanks Ardvark, I will check it out. My Creator actually came with simplify3d. But my computer does not have an SD card reader yet, and the computer is in a room too far away for a USB cable. I was expecting to test it out with the SD card that was supposed to come with the printer. No Luck. So I have ordered an SD card reader, I should be able to pick it up later today.
I assume I can also print G-code and .stl files?
-
02-12-2016, 04:42 PM #4
- Join Date
- Aug 2015
- Posts
- 256
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion