Quote Originally Posted by EagleSeven View Post
Need to determine if 200C is Actual temp at nozzle ?
I've found there can be up to 20C difference in displayed temp and Actual.
(I use a digital-thermometer, with thermocouple-probe, in direct contact with nozzle)

Also, Not all PLA filament is the same, some require slightly higher temp than other spools,
and there can be Bad spots in filament spools.

I read about some tests that were done,
and they found that different areas of filament on a spool were different strengths and flexibility.
So would you say that since this is a cheaper filament (Inland from Microcenter) that there is a chance that this is just fluky.