Results 1 to 10 of 84
Threaded View
-
01-17-2016, 10:19 AM #11
I'll Try and help..
You need to setup the card first through the Flashair utility. Once you get that correct then you need to open the CONFIG file and make the appropriate entries. I've used Notepad++ with out any problems, but make sure you use the USB safe remove system before removing the SD card from your computer. The Network keys must be set by the utility, so trying to add them to the CONFIG file wont work.
Here is a copy of my CONFIG,
CIPATH=/DCIM/100__TSB/FA000001.JPG
APPMODE=6
UPLOAD=1
UPDIR=/files/
APPNAME=3DPrint
APPNETWORKKEY=********************
VERSION=FA9CAW3AW3.00.00
CID=THIS WILL BE UNIQUE TO YOUR CARD
PRODUCT=FlashAir
VENDOR=TOSHIBA
APPSSID=GBSV2
LOCK=1
DNSMODE=1
BRGSSID=GBSV2
BRGNETWORKKEY=********************
APPAUTOTIME=180000
DHCP_Enabled=NO
IP_Address=192.168.1.14
Subnet_Mask=255.255.255.0
Default_Gateway=192.168.1.1
Preferred_DNS_Server=192.168.1.1
NOISE_CANCEL=2
WEBDEV=2
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help