Results 1 to 10 of 84
Threaded View
-
01-13-2016, 11:29 AM #11
OK so after a bit of testing/experimenting this is what I've discovered. There are no file locks (at least none that Windows 10 honors) being placed on the current file being printed. Small files (not sure of the size breakpoint here) are completed loaded into memory, and can be deleted from the SD card after the print starts. This worked for the files under 1meg I tested.
Files over 10 megs:
1) there are no file locks (at least none that Windows 10 honor) being placed on the current file being printed.
2) Renaming the file, then renaming back does not effect printing.
3) Renaming the file and leaving it for 10 seconds does not effect printing.
4) Coping and pasting the same file that is being printed does not effect printing.
5) Renaming the file and leaving it causes the print to fail. (as would be expected)
6) Deleting the file after print has started causes the print to fail. (as would be expected)
All-In-all, fairly robust all things considered. It would be nice to have some file locks, but......Last edited by ServiceXp; 01-13-2016 at 12:03 PM.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion