Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 84

Threaded View

  1. 01-11-2016, 11:21 AM #11
    EagleSeven
    EagleSeven is offline
    Engineer EagleSeven's Avatar
    Join Date
    Jul 2015
    Posts
    553
    Quote Originally Posted by Mjolinor View Post
    The printer only understands X3G so whether or not you use USB or SD the printer still only understands X3G

    If you use Repg to send over USB then RepG translates to X3G before it sends it. RepG is not a slicer it is front end to assist in slicing and talking to the printer. Makerbot Desktop is a slicer (IIRC though I don't use it) and it too converts to X3G before sending it to the SD card or to the printer directly over USB.
    *** Wrong ***

    Where are you getting this 'Wrong' Information ??

    If you dreamed it, it Don't count !

    Last edited by EagleSeven; 01-11-2016 at 11:27 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules