Results 1 to 10 of 84
Threaded View
-
01-11-2016, 08:06 AM #11
That is true if you are using an SD card, plugged into printer (SD requires .x3g) ,
but if using a computer thru USB cable connection there is No translation to .x3g involved,
when using Makerbot or Rep-G slicers, (not sure about other slicers).
That is what I've read about how it works in our CTC printer,
I assume other similar printer makes are Same.Last edited by EagleSeven; 01-11-2016 at 08:22 AM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion