Results 11 to 12 of 12
Thread: BETA Delays
-
02-26-2014, 09:38 PM #11
- Join Date
- Oct 2013
- Posts
- 14
I can sympathize with every post on this thread so far because I am as impatient as the next beta tester. That being said I was definitely thinking some of the same things tookys was as I'm sure a lot of you are too but I wanted to point out that Rylan, the head of this entire project, just posted to try and explain himself. He is trying to manage our expectations and is doing a very good job of it. He is not hiding and I think we all should just trust that he is doing what's best for this project. At this point no one knows the Peachy Printer better than he does.
Thanks to everyone that's doing there jobs to get this printer out!
-
02-27-2014, 10:20 AM #12
Rylan added this :
In fact we are already working on our own current limiting ciruit so that we wont have this problem in the future.To prevent further delays to the Beta tester group we have orderd circuits that work with the lasers we have now.
We will take the time to do the r and d of our own laser driver and put it on our own circuit before we order the next batch of peachy circuits.
We will make it even more hackable while were at it because this way if you want to change lasers all you need to do is change out the laser diode.
not the hole laser( circuit, lens , aperture, heat sink, focus ring)
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion