Saving G29 Bed Level Correction Matrix to EEPROM

[Fri]

I tried the lastest marlin branch and I really love it, it's got some great features. Unfortunately the ABL has still the same issues. I also couldn't get the lcd to work FYI.

[adamfilip]

Any news or progress. im using a fairly recent build. but my bed looks flat but has some dips and standard ABL doesnt compensate for that.
Id love to get a Matrix version to work its magic. any news on what release will have this?

[Roxy]

Any news or progress. im using a fairly recent build. but my bed looks flat but has some dips and standard ABL doesnt compensate for that.
Id love to get a Matrix version to work its magic. any news on what release will have this?

The Mesh bed leveling is definitely gaining favor! The only thing I don't like about it is you have to manually create the mesh. But I think that is going to change in the next 6 months. (And actually... On Delta's, the mesh is created automatically, but just not saved right now.)

[adamfilip]

if the mesh is manually made once can it be saved?

[Roxy]

if the mesh is manually made once can it be saved?

With just a couple changes to the firmware. I think it makes sense to unify the two mesh leveling methods. So, in the future I suspect that will happen. But it can be done one-off with just a few lines of code.

[adamfilip]

Im not well versed in the language. would you be able to post the necessary code ?

[Roxy]

Im not well versed in the language. would you be able to post the necessary code ?

It's a good chance to learn the language. I'm bringing up my Delta printer right now. And I'm thinking I want a highly detailed mesh that I don't want to have to probe for each print. So pretty soon, it will show up in the development branch of Marlin if you get stuck.

[adamfilip]

Im trying out the mesh levelling. after the manual levelling. I dont want to save the settings to EEPROM. I want to enter the values into Marlin. where can I enter those values?

[adamfilip]

or via Gcode prior to a print job

[Roxy]

Im trying out the mesh levelling. after the manual levelling. I dont want to save the settings to EEPROM. I want to enter the values into Marlin. where can I enter those values?

I have not used the Mesh leveling yet. Somebody else will have to jump in and help.