PLA extrusion problem

[ohms]

Hi, I started printing in PLA and everything was fine, but recently, the filament stopped extruding continuously through the nozzle even though I didn't change any of the settings. I'm pretty sure it has something to do with the filament because I switched to abs and it worked fine, even on nylon and ninjaflex. It had been raining for a few days so I thought maybe it absorbed some humidity so I followed this http://www.taulman3d.com/drying-materials.html to try and dry it for about 5 hours. Still, i can see the extruder skip some steps at intervals. I am printing on an airwolf HD. I was printing at 195 just fine for a couple of weeks, then I tried 200 and 205 once it started malfunctioning but no luck.

Any help is appreciated.

[LAFilament.com]

I hate to point the finger at the filament but, it seems like you confirmed it with the other materials....

[Roxy]

OK??? And my guess with no other information is he bought some cheap filament off of eBay. I do that all the time. And I get stung again and again....

And I'll give you one guess where the cheap non-working filament comes from....

[curious aardvark]

america ?
;-)

[LAFilament.com]

Shame shame shame

[ohms]

I actually got it straight from airwolf. What I'm confused about is that it printed well for a while, then suddenly I ran into this problem