I've recently bought a ElecFreaks 3D Printer but there were a few major problems.
1. The filament defies the laws of gravity and floats up to ball on top of the nozzle
2. Even if it doesn't ball up it doesn't stick to the base. I use the special masking tape and board. I also adjusted the base height for around 2 hours with trial and error
I don't see ANY forum posts or internet posts about this printer, only people just staring into the future of 3D Printers. Theres a 10/90 chance that the machine will work, and only when i scrape it off at the right time.
PLEASE help me with this, as many other people are probably having the same problem as I am.