New Matter updates

[Feign]

Well, I've finally finished out my free half-kilo of SUPER FREAKING PINK filament, unfortunately I wasn't paying attention at the end of the spool and I got to experience clearing out my first jam...

Long story short, it was a heck of a lot easier than with a Makerbot, the hot end unplugs from the head unit and simply unscrews (they even have an instructional video on youtube for it) after that it's a simple matter of plugging it back in, heating it back up while unscrewed and pushing the filament the rest of the way through (with proper protective gear, of course) The whole process took about 5 minutes.

[Robotico]

Has anyone found any YouTube videos yet from users? I can't find any except ones from the official New Matter channel. Was hoping to see some "raw" footage to hear what it sounds like and get a feel for the real unit, not so glossy, if you will.

Check this out:

https://www.youtube.com/watch?v=k_049B56ifQ

[jamesarm97]

Is there a firmware change log anywhere? It would be nice to know what each firmware release changed instead of guessing and looking for differences. (i.e. just updated to 0.2.0)

[tastewar]

Ditto! Your early users really need this. I attempted to print the 2-sided pumpkin from the store, and after something like 18 hours, it appears to have simply stopped. Is that something that's likely to be fixed? What about the wifi problems? Are they fixed?

[Robotico]

https://www.reddit.com/r/3Dprinting/..._but_detailed/

[tastewar]

Well, you specifically asked about sound, and I didn't include the sound, and it's sped up 8x, but here's something: https://youtu.be/K1uD0gRSx0Y

[curious aardvark]

lol love the way the printbed moves around.

[KMToydarian]

Well, you specifically asked about sound, and I didn't include the sound, and it's sped up 8x, but here's something: https://youtu.be/K1uD0gRSx0Y

Looking forward to the day when that print speed is real time!