Results 1 to 10 of 17
Thread: Motor trouble
Threaded View
-
07-12-2015, 11:34 AM #17
- Join Date
- May 2015
- Posts
- 5
I agree that these problems need to be documented and saved for those in the future having similar problems. They can find the answer much quicker than we did.
Screenshot 2015-07-12 09.32.40.jpg.
Here is the adjustment I made to the XY speed, that started the issues I was having.
I tried to print ABS and started having problems again. The only thing that changed was the temps. More detailed troubleshooting and I found two of the motor wires to have an intermittent break. While it was printing I could move the wires and cause it to start skipping. Release them and it would stop. Removed about a 4" section in both wires about 2" from the motor connector, and it is again working without issue. I added a section of heat shrink tubing at the connector and then changed the layout of the wires and let them hang down from the motor with a loop back up to the top support. I then put a section of plastic split loom covering on it. Much less flexing of the wire harness now.Last edited by Raimond; 07-16-2015 at 07:43 PM. Reason: Added new info
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion