Results 1 to 10 of 24
Threaded View
-
07-06-2015, 01:51 PM #19
Interesting results. Took the model from the second picture, and applied a rounded corner as you suggested.
servosleddeformc2.JPG
Took a big step backwards. LOL. Interesting.
Edit:
Ok, jsut remembered what The OP jsut mentioned, Red does not mean bad.
In the original design red = 8.03 somethings (The unit is not specified).
In design 2, red = 5.4 somethings.
In the latest design, red = 2.6 somethings.
So yes, it looks like it took the stress, spread it out, and reduced it by a quarter.
It'd be really nice if I could mouse over the color scale bar at the bottom and have it say what the value is, as the scale is probably not linear.Last edited by Marm; 07-06-2015 at 01:59 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion