Results 1 to 3 of 3
Thread: Prusa i3 building
-
05-04-2015, 09:42 PM #1
- Join Date
- May 2015
- Posts
- 1
Prusa i3 building
hey i yust bought a prusa i3 from 3dprintersonlinestore it comed well pakaged and was made of very nice acrylic parts i built up the mechanical part in 5 hours then wired yaaay now im in the part of calibration but ... what software do you recomend for calibrating?
-
05-07-2015, 03:52 PM #2
- Join Date
- Jan 2014
- Posts
- 462
There's a good description of the calibration process over at the reprap wiki:
http://reprap.org/wiki/Calibration
The calibration process doesn't require any software above and beyond what you normally use for 3D printing.
-
05-07-2015, 04:21 PM #3
Welcome! The Prusa i3 is an amazing 3dp & will serve you well
New Here, don't print but need a...
06-20-2024, 12:18 PM in General 3D Printing Discussion