C42, per your instructions.. The hot ends should be 20 mm apart..mine are 26 apart..i cant see how 20mm is a achievable without having the slanted inwards towards each other..this measuring from tip to tip
Originally Posted by jasay
From the OP:
The older design of IBDE is 20mm. Can't get to c42's website from work to see if the assembly instructions have a copy/paste error from the other design.
Originally Posted by voodoo28
.the site says 20mm under installation instructions..
Originally Posted by sniffle
It's 25mm on center for the Flex E3D i would assume it's the same for the hexagon's
Ugh. Yes. It should say 27mm. I have updated the pages I could find. If you find that error anywhere else, please let me know.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion