Results 1 to 10 of 113
Thread: PEI Sheet for Bed Adhesion
Threaded View
-
03-24-2015, 05:59 PM #27
I still get some lift, I think I need to build an enclosure. However when I use a brim I don't have lifting problems, just would prefer not to print with a brim. I sand mine with like 1,000 grit, and then wipe it down with rubbing alcohol. I print at 105 to 110 bed temp, been tempted to try higher but haven't yet.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion