Results 1 to 7 of 7
Thread: Build Plate Not Level
Threaded View
-
01-29-2015, 06:55 PM #2
Yep it is normal gantry sag. Just never check the center. lol Warm build plate (not extruder) up to 60-80c then set the gap over the 3 adjusters. Don't go all the way out to the edges, the plate teters a little. Just over the adjusters is good enough.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion