Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 476

Threaded View

  1. 01-10-2015, 11:59 AM #11
    csader
    csader is offline
    Student
    Join Date
    Dec 2014
    Posts
    49
    Couldn't find the answer to this anywhere:

    When wiring up the second extruder, I get that we use E1 for the motor and D9 for the heater. I'm assuming I use T2 for the thermistor? Is there anything else I need to do in the firmware to associate the two?

    Also, does the LCD display temps for both hotends?
    Last edited by csader; 01-10-2015 at 12:06 PM. Reason: clarity
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules