Results 1 to 10 of 189
Thread: Show your MODS
Threaded View
-
10-16-2014, 09:38 AM #11
Has anyone ran a much smaller extruder setup on a Prusa? (I assume that would be needed to run dual extruders)
Something like this?
I would think this would be a much better setup for several reasons.
Less bulk and weight to be moved around and supported.
Less parts to go bad, eliminating 2 plastic gears.
Seems there would be more torque on the motor since its not using gearing, is there any other disadvantages?
I would love to have a setup like that on the Prusa. Looks like an easier to maintain setup to me.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion