Help -> Bad & Unusual printing results

[2fast4myself]

Hi guys

thank you for all your help

Do you have the Zprobe installed? I cannot see it in the photo.

i dont have it yet.
Read on the net that there is no better calibration than old fashion paper method,...(don't know if this is true)

If one or more of his arms are even slightly out of length, when the head moves around, it will actually tilt the end effector off the horizontal axis, therefore tilting the nozzle when it gets to the outer edges of the plate.

I have measured each rod and all have less then 1 mm tolerance.

Also the prints that i've done are all in the radius of 4 cm frome the center and the effector doesn't come close to the edge.

Is there something i can do (print something, or try something with the delta) to help you guys figure it out ?