Bed auto leveling works, but x/y axis are off with correct offset

[Pronus]

I had the #define AUTO_BED_LEVELING_GRID_POINTS set to 2 previously when I was experiencing issues trying to get the first probe to probe right, but later switched the value to 3 when printing. I'll try changing the value to 4 and see if that makes a difference.

Also, when z-probing used to happen, each time a point was probed, pronterface would send back commands of the x/y/z location but since the change to your code base it is not relaying that back. This is completely ok though if I can access this Topography report. How do I access this report?


-------------------------------------------------------------------
I just changed the value from 2-4...but here is where things get weird. Changing the value is not changing how many probing points that G29 is performing anymore. A value of 2 probes 9 points...which should be what happens when the value of 3 is chosen. I switched to 4 and I am still only probing 9 points.