Quote Originally Posted by clough42 View Post
I have my printer sitting on a Travertine tile. The tile provides a flat surface so the printer is always square and doesn't twist when placed on different or flexible surfaces. The tile also adds mass to the surface, reducing the amount of sound and vibration transmitted to the surface. This works especially well with the Sorbothane isolator feet because it provides a vibration sink that improves the isolation.

You can get an 18" square tile at Lowes or Home Depot in the US, usually for less than $10. I put felt pads under the corners of the tile so it conforms to the table it's sitting on.


2014-08-12 09.10.26.jpg
Next time I'm at Home Depot I'm going to see if I can get a big, flat 18" tile. I'm thinking wiith a diamond bit in a Dremel tool and water pouring on it... I can drill holes in the right place to Tie Wrap it down hard to the tile. Then I might be able to safely move my printer around.