Results 1 to 10 of 189
Thread: Show your MODS
Threaded View
-
08-11-2014, 11:02 AM #11
Good tip. I'll have to try the clean cut.
I've been using the cheap stuff, sold on eBay by seller "furryletters". It can unravel, but I just cut it with scissors and try to be careful with it. I secure the ends with heat shrink and zip ties. Another approach is hot glue lined heat shrink. I've been known to cut a sliver off a hot glue stick and shove it in the heat shrink to help secure the sheathing so it doesn't pull out. Zip ties are easier.
One other tip: the sleeving melts very easily. Be careful when shrinking the tubing. I actually use a hot air solder rework station, which is way overkill, but really easy to control.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion